The model ISTOBAL HW’DRIVE2 has been designed to fulfil different demands with large vehicles, from bus or trolley bus fleets to any type of trams. This model has a lower height and it is open at the top, which makes it suitable for vehicles with an overhead catenary. It includes a pre-soak arch, two rinsing arches, a displaced technical board with a touch screen, soft starters for its four brushes, and speed detection to avoid vehicle impacts. Until now it was unachievable to reach spectacular results in drive though tram wash and ISTOBAL guarantees it with our ISTOBAL HW’DRIVE2 model. FRONT AND REAR WASH SIDE WASH • Tilting brushes for trams: top part with pneumatic tilting enabled by cylinders, and bottom part with fixed tilt. • Rotary joint between brushes for greater stability. • System for more adaptability to the shape of the vehicles and for greater efficiency with trams. • Upper vertical brush with minimum tilt to scan tram sides. • 1/2 and 3/4 brushes spin in opposite directions for a better finish • Soft starters for the 8 motors. Tangential tilting prevents brushes from moving into the interconnections between coaches. • Cylinder system: Brush arms with limit switches. • Cylinder control by wash zones: Front, side, back. FEATURES ISTOBAL HW’DRIVE2 - TROLLEY BUSES AND TRAMS DRIVE THROUGH WASH TOUCH SCREEN OPTIONAL EXTRAS • Control panel with touch screen model KTP400 by Siemens, installed on the door of the electrical cabinet, next to the emergency stop button. The touch screen allows users to carry out all control, configuration and maintenance tasks in a user-friendly way. • Possibility of sending emails and optional Screen Access to control the facility remotely. • Exit traffic light to indicate rear wash. • Wax dosing. • Integrated underchassis wash, 20 bar [290Psi]. • Demineralising unit. • Recycling unit. • esens ® chemical products. *Figures in brackets estimated using US Imperial System equivalents. In case of doubt or inconsistency, the International System (Metric Dimensions) shall prevail. A B C D A - Machine height: 4,700 mm [15’-5”] B - Wash height: 4,100 mm [13’-5 3/4”] C - Bay width: 5,500-6,000 mm [18’-1/2”]-[19’-8 1/4”] D - Bay length: 15,000-16,000 mm [49’-2 1/2”]-[52’-5 7/8”] A B C D ISTOBAL HW’DRIVE
HW'DRIVE Page 2 Page 4